![]() Once again, there are No Refunds on this Item. If this Full Wave Control Panel is installed into a Stand with a Half Wave Magnetic Base, the Control Panel will be Destroyed. If the reading is between 37 and 45 Ohms, this part won't work, you will need the Half Wave Control Panel. The Resistance of a Proper Operating Full Wave Magnetic Base Should be Between 97-119 Ohms. Measure the Resistance Across the 2 Lead Wires with the Base Disconnected from from the Stand. The 4203 electromagnetic variable speed adjustable base features solid state electronic switching and an 11 in. To Determine If Your Magnetic Base is Full Wave or Half Wave, Disconnect the 2 Magnetic Lead Wires (A and B) going from the Magnetic Base to the Control Panel. Before Purchasing, you must make sure you are ordering the correct part. 54-30-0450 FOR OPERATIONAL CHECK LIST AND WIRING INSTRUCTIONS FOR MAG STANDS Using a 7/8' crows foot wrench, apply 45 in/lbs of torque to the pigtail tting and 35 in/lbs of torque to the locking nut when assembling the power cord (66) to the control panel (67). As part of MSC Industrial Supply's Power Tools offering, this item can be found using MSC part number 65056400. Part # 23-35-0312 Replaces Part # 23-35-0311įits the following Tools: 23-35-0300 Mag Stand Control Panel 4201 (SER 498-11741) Medium Base Electromag Drill Press StandĤ201 (SER 498-13900) Medium Base Electromag Drill Press StandĤ201 (SER 498A) Medium Base Electromag Drill Press Stand 4202 Electromagnetic Drill Press StandĤ202 (SER 598-1001) Electromagnetic Drill Press StandĤ202 (SER 598-10475) Electromagnetic Drill Press StandĤ202 (SER 598A) Electromagnetic Drill Press StandĤ202 (SER 598B) Electromagnetic Drill Press StandĤ202 (SER 598C) Electromagnetic Drill Press Stand 4203 (SER 838A) Electromagnetic Drill Press StandĤ203 (SER 838B) Drill Press 4221 (SER 499-7780) Large Base Electromag Drill Press StandĤ221 (SER 499-8750) Large Base Electromag Drill Press StandĤ221 (SER 499A) Large Base Electromag Drill Press Stand 4231 (SER 500-13210) Adjustable Base Electromag Drill Press StandĤ231 (SER 500-15800) Adjustable Base Electromag Drill Press StandĤ231 (SER 500A) Adjustable Base Electromag Drill Press Stand Important: This is a Full Wave Magnetic Base Control Panel Kit. MAG STAND WIRING INSTRUCTION 54-30-0450 SEE BULLETIN NO. The Milwaukee Tool Corded Electromagnetic Drill: 1-1/4' Chuck, 11' Travel 120V, 12.5A, 9' Cord can be found within the Portable Drill Presses category.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |